Series 10,000 Specifications

SERIES 10,000 SPECIFICATIONS

FILM DRIVE SYSTEM

Crystal speed control, stepping motor sprocket drive, CMOS logic and control, 2x speed local, 4x with MTE projector. Sprocket de-clutch for start mark alignment. Machine can be cued on and off running interlock buss with no interruption to buss. 16mm, 35mm speeds push-button selected interlock buss selection from four sources. Dual gage sprocket pads. Drive signal may be looped to drive several machines.

REEL SPINDLE DRIVE & CONTROLS

Single Phase Torque motors, reel size take-up torque selector, selector CW/CCW rotation upper & lower spindle, automatic film cutoff switch, wind and rewind push buttons.

REWIND TIME

400 feet 1 minute, 1000 feet 2 minutes, 2000 feet 3 minutes, 3000 feet 4 minutes, 6000 feet 6 minutes.

REPRODUCE OUTPUT

600 Ohms ungrounded + 4VU

RECORD INPUT

15K bridging +4VU buss

DISTORTION

0.5% THD at +16dbm output level

FREQUENCY RESPONSE

Standard SMPTE or CCIR curves for 16mm, 35mm, and 17.5mm

FLUTTER

0.06% RMS at 90 FPM
0.08% RMS at 36 FPM

SIGNAL TO NOISE RATIO

70db below 100% output

MAGNETIC HEADS

35mm: 1, 3, 4, & 6 track

16mm:    200 mil edge track or 200 mil center track
             160 mil 2-track EBU
             160 mil 2-track EBU + code track
             90 mil 3-track
             60 mil 4-track
             100 mil stripe

17.5mm: 200 mil

POWER

115V/220Volt, 50/60 Cycles

DIMENSIONS

83" H x 18" D x 22" W

WEIGHT

300 Lbs.

STANDARD MODELS

Type 10036 16/35mm 36 + 90 FPM
Type 10036/7 16/17.5/35mm 35 + 45 + 90 FPM
Prefix MD denotes reproducer
Prefix MR denotes erase/"pickup", record/reproduce