SERIES 10,000 SPECIFICATIONS
|
|
| FILM DRIVE SYSTEM |
| Crystal speed control, stepping motor
sprocket drive, CMOS logic and control, 2x speed local, 4x with MTE
projector. Sprocket de-clutch for start mark alignment.
Machine can be cued on and off running interlock buss with no
interruption to buss. 16mm, 35mm speeds push-button selected
interlock buss selection from four sources. Dual gage sprocket
pads. Drive signal may be looped to drive several machines. |
| REEL SPINDLE DRIVE & CONTROLS |
| Single Phase Torque motors, reel size
take-up torque selector, selector CW/CCW rotation upper & lower
spindle, automatic film cutoff switch, wind and rewind push buttons. |
| REWIND TIME |
| 400 feet 1 minute, 1000 feet 2 minutes,
2000 feet 3 minutes, 3000 feet 4 minutes, 6000 feet 6 minutes. |
| REPRODUCE OUTPUT |
| 600 Ohms ungrounded + 4VU |
| RECORD INPUT |
| 15K bridging +4VU buss |
| DISTORTION |
| 0.5% THD at +16dbm output level |
| FREQUENCY RESPONSE |
| Standard SMPTE or CCIR curves for 16mm,
35mm, and 17.5mm |
| FLUTTER |
0.06% RMS at 90 FPM
0.08% RMS at 36 FPM |
| SIGNAL TO NOISE RATIO |
| 70db below 100% output |
| MAGNETIC HEADS |
| 35mm: 1, 3, 4, & 6 track |
16mm: 200 mil edge track
or 200 mil center track
160 mil 2-track EBU
160 mil 2-track EBU + code track
90 mil 3-track
60 mil 4-track
100 mil stripe |
| 17.5mm: 200 mil |
| POWER |
| 115V/220Volt, 50/60 Cycles |
| DIMENSIONS |
| 83" H x 18" D x 22" W |
| WEIGHT |
| 300 Lbs. |
| STANDARD MODELS |
Type
10036 16/35mm 36 +
90 FPM
Type 10036/7 16/17.5/35mm 35 + 45 +
90 FPM
Prefix MD denotes reproducer
Prefix MR denotes erase/"pickup", record/reproduce |
